EQ & filters

The low end carries most of a track's energy. Learn how much your mixer's EQ really cuts, the bass swap, and filter fades.

Beginner3 lessons · 16 minReviewed 17 Nov 2026
Lesson 016 min

EQ vs isolator

An EQ turns a band down. An isolator removes it.

Club mixers use 3-band or 4-band channel EQs. On the Pioneer DJM-900NXS2 each band runs from -26 dB to +6 dB in EQ mode, and an EQ/ISOLATOR switch turns that into a full kill [1]. On the 4-band DJM-V10 the outer bands kill fully while the two mids stop at -26 dB [2]. The Allen & Heath Xone:96 publishes its crossover points: low at 180 Hz, high at 3 kHz [3].

Deepest EQ-mode cut on a DJM-900NXS2 [1]
-26 dB
Maximum boost per band [1]
+6 dB
Isolator mode: the band is gone [1]
-∞
Xone:96 low and high crossovers [3]
180 Hz / 3 kHz

An EQ attenuates a band; an isolator removes it [4]. Software varies too: djay's Classic EQ goes from -24 to +6 dB, and its Isolator mode kills fully [5].

Lesson 025 min

The bass swap

Never let two basslines play at full strength together.

The low band carries the most energy and takes up the most headroom [6]. Bass waves are also long: a 50 Hz wave is so long that two bass sounds slightly out of sync can cancel each other out [7]. Native Instruments notes that low frequencies are the most common source of a muddy mix [8].

  1. 01Beatmatch the incoming track.
  2. 02Cut its low EQ before you bring it in.
  3. 03Raise its fader during the outgoing track's phrase.
  4. 04On the next phrase, raise the incoming low as you cut the outgoing low [8].
Lesson 035 min

Filters and the filter fade

High-pass to bring a track in, low-pass to take one out.

A high-pass filter strips away the bottom as you turn it up; a low-pass filter takes off the top as you turn it down [9]. On the DJM-900NXS2, FILTER is one of six one-knob Sound Color FX, alongside SPACE, DUB ECHO, SWEEP, NOISE and CRUSH [1].

  1. 01Start the incoming track with its filter turned fully to high-pass, so there's no low end.
  2. 02At the mix point, raise its fader and sweep the filter back to centre.
  3. 03Sweep the outgoing track to full low-pass, then fade it out [8].

Native Instruments recommends the filter fade for busy tracks [8]. If your filter sits on an effects unit, Digital DJ Tips suggests about 30–40% wet/dry [10].

Sources

  1. [1]DJM-900NXS2 operating instructions · Pioneer DJ
  2. [2]DJM-V10 specifications · Pioneer DJ
  3. [3]Xone:96 user guide · Allen & Heath
  4. [4]Isolator (glossary) · Mixgraph
  5. [5]djay settings: sound · Algoriddim
  6. [6]Bassline (glossary) · Mixgraph
  7. [7]Phase cancellation · EDMProd
  8. [8]DJ transitions · Native Instruments
  9. [9]Kill EQ (glossary) · Mixgraph
  10. [10]A beginner's guide to DJ effects · Digital DJ Tips